msgbartop
Provides Technical Information of GPS Receivers & Data Logger
msgbarbottom

05 Oct 19 How to change the GNSS100L or GNSS200L usb GPS update rate to 10hz?

By default, GNSS100L or GNSS200L update rate has been set to 1hz. If you want to change it to 10hz. Please follow the below 9 steps.

Pre-request:
You might need to install GNSS100L/GNSS200L usb driver and ublox u-center software to a computer if it didn’t already installed. Please plug in your usb GPS to the computer. Open the u-center software. Select the corresponding com port for the usb GPS. Please make sure the usb GPS is connected to the computer during the below steps.

step 1. click the “message view” icon.
step 2. expand the UBX tree

step 3. click the “RATE(rates)”
step 4. If you want to update the GPS update rate to 10Hz, please change the Measurement Period to 100 [ms}. Or if you want to update the GPS update rate back to 1Hz, please change the Measurement Period to 1000[ms]
step 5. press the “Send” button

step 6. click CFG(Configuration).
step 7. on the right panel, select “Save current configuration”
step 8. select all Devices “0- BBR, 1- FLASH, 2- I2C-EEPROM, 4- SPI-FLASJ”
step 9. press the “Send” button again.

Comments are closed.